Scaffolding clamps 76.1 mm (2½")

Minimum order quantity 200 pieces. Lead time approx. 3 monthsCross clamps/standard couplers are used as a rigid connection between two scaffolding tubes. The angle between the two tubes is 90 degrees. It is important to use only certified couplings to ensure reliable safety and compliance with approval standards. Scaffolding couplings are also frequently used for anchoring scaffolding. In this case, the scaffolding clamp is used to secure the steel tube brace (scaffolding anchor) to the scaffolding frame. Material, properties and features: Steel, drop-forged, hot-dip galvanised, robust design, ribbed Quick-connect thread Test mark in accordance with EN 74 With flanged nuts 19 mm or 22 mm Flange nut and hammer-head screw electro-galvanised Approved as a single coupling for a load of 9.1 kN or as a double coupling for 15.2 kNTightening torque for flanged nuts 50 Nm 1920g, FV

600 g Application: Half couplings are essentially half-rotary couplings. At the point of the rotary connection, there is a hole in the coupling base (17 mm diameter), so that the coupling can also be bolted in place using a flat-head screw. Material, properties and features: Steel, drop-forged, hot-dip galvanised, robust design, ribbed Metric thread or quick-connect thread (depending on batch) Test mark in accordance with EN 74 With flanged nuts, 22 mm wrench size Flange nut and hammer-head screw hot-dip galvanised Approved as a single coupling for a load of 9.1 kN Tightening torque of the flanged nuts: 50 Nm Additional information and notes: This coupling is also available completely unfinished to simplify welding

FV Application :Reducing swivel couplings are used as a rotating connection between a scaffolding tube and a tube with a different diameter. The angle between the two tubes can be freely selected. The different diameter may be smaller or larger than 48.3 mm – in this case, 76 mm. Material, properties and features :• Steel, drop-forged, hot-dip galvanised, robust design, ribbed • Metric thread or quick-connect thread (depending on batch) • With flanged nuts, 19 or 22 mm spanner size. Flanged nut and hammer-head screw electro-galvanised or hot-dip galvanised (depending on batch)  Additional information and notes :• If you require larger quantities than those shown as “in stock”, please contact us; we can usually assist you • Upon request, we are also happy to offer you reducing rotary couplings in the following combinations: SW 19 For pipe Ø 48x34 mm SW 19 For pipe Ø 48x38 mm SW 19 For pipe Ø 48x42 mm SW 19 For pipe Ø 48x60 mm SW 19 For pipe Ø 48x76 mm